3com 5500-ei pwr Guía De Referencia

 

1-55 

[Sysname] radius scheme radius1 

New Radius scheme 

[Sysname-radius-radius1] state secondary authentication active 

  

RADIUS scheme view 

None 

Use the stop-accounting-buffer enable command to enable the switch to buffer the stop-accounting 
requests that get no response. 

Use the undo stop-accounting-buffer enable command to disable the switch from buffering the 
stop-accounting requests that get no response. 

By default, the switch is enabled to buffer the stop-accounting requests that get no response. 

Stop-accounting requests are critical to billing and will eventually affect the charges; they are important 
to both users and ISPs. Therefore, the switch should do its best to transmit them to RADIUS accounting 
servers. When getting no response to such a request, the switch should first buffer the request on itself, 
and then retransmit the request to the RADIUS accounting server until it gets a response, or the 
maximum number of transmission attempts is reached (in this case, it discards the request). 

Related commands: reset stop-accounting-buffer, 

, 

. 

# In RADIUS scheme radius1, enable the switch to buffer the stop-accounting requests that get no 
response from the servers. 

<Sysname> system-view  

System View: return to User View with Ctrl+Z. 

[Sysname] radius scheme radius1 

New Radius scheme 

[Sysname-radius-radius1] stop-accounting-buffer enable 

timer seconds