3com 5500-ei pwr Guía De Referencia

 

1-32 

[aaa_0.Sysname-cluster] logging-host 10.10.10.9  

management-vlan vlan-id 

undo management-vlan 

System view 

vlan-id: ID of the VLAN to be specified as the management VLAN. 

Use the management-vlan command to specify the management VLAN on the switch. 

Use the undo management-vlan command to restore the default management VLAN. 

By default, VLAN 1 is used as the management VLAN. 

When specifying the management VLAN, note that: 

z 

The management VLANs on all the devices in a cluster must be the same. 

z 

You can specify the management VLAN on a device only when no cluster is created on the device. 

You cannot change the management VLAN on a device that already joins a cluster. If you want to 

change the management VLAN on a device where a cluster has already been created, you must 

first remove the cluster configuration on the device, then re-specify a VLAN as the management 

VLAN, and finally re-created the cluster. 

z 

The management VLAN of a cluster defaults to VLAN 1. To isolate cluster management packets 

from other packets to improve the cluster information security, it is recommended to configure the 

management VLAN of the cluster as another VLAN. 

# Specify VLAN 2 as the management VLAN of the current switch. 

<Sysname> system-view 

System View: return to User View with Ctrl+Z. 

[Sysname] management-vlan 2 

nm-interface Vlan-interface vlan-id 

Cluster view 

vlan-id: VLAN ID, in the range 1 to 4094. The VLAN specified by this argument must have been 

configured with a VLAN interface address.