3com 7000 Manual Suplementario
Physical-Link Failure Indicator
125
Physical-Link Failure
Indicator
Indicator
The following commands allow you to configure the physical-link failure
indicator.
indicator.
■
■
For more information about the physical link failure indicator,
“Physical-Link Failure Indicator” on page 128 in the Operations Guide.
“Physical-Link Failure Indicator” on page 128 in the Operations Guide.
Display Link-Failure
Indicator Sensitivity
Displays the enable/disable status and the sensitivity for the link-failure
detection mechanism of the CoreBuilder 7000 family ATM switch. For
more information, “Link-Failure Detection Sensitivity Control” on page 129 in the Operations Guide.
detection mechanism of the CoreBuilder 7000 family ATM switch. For
more information, “Link-Failure Detection Sensitivity Control” on page 129 in the Operations Guide.
Command Actions
Command Result
Example
Enter:
1 1 11 1
The following message is displayed:
Current port link down indication status is: Enabled
Sensitivity: Medium
Enter the menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(11) PLD: Port link down indication
(1) GET: Get Port link down sens
Direct access sequence:
1 1 11 1
System action taken:
The link-failure mechanism status for the switch is
displayed.
displayed.
System message display:
Current port link down indication
status is: Enabled/Disabled
Sensitivity: Low/Medium/High