3com 7000 Manual Suplementario
148
C
HAPTER
6: ILMI C
ONFIGURATION
Enable/Disable
Change of
Attachment-Point
Enables or disables the change of attachment-point mechanism for the
specified port in the CoreBuilder 7000 family ATM switch.
specified port in the CoreBuilder 7000 family ATM switch.
ILMI channel polling must be enabled if the change of attachment-point
facility (COAP) is enabled (“Enable/Disable ILMI Channel Polling” on
page 137).
facility (COAP) is enabled (“Enable/Disable ILMI Channel Polling” on
page 137).
Before enabling COAP, verify that all attached ATM edge devices support
ILMI 4.0. If they do not, they can fail.
ILMI 4.0. If they do not, they can fail.
Command Actions
Command Result
Example
Enter:
1 1 8 2 1 3.2 1
The following message is displayed:
Change of attachment-point is set to ENABLED
The change of attachment-point status of port 3.2 is enabled.
Enter the menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(8) IME: ILMI setup
(8) COA: COAP setup
(2) SET: Set&save COAP status
Enter a parameter at the prompt
Parameter
Format or Range
Port ID
slot.port
Change of
attachment-point
enable/disable
attachment-point
enable/disable
0
to disable change of attachment-point
1
to enable change of attachment-point
Direct access sequence:
1 1 8 8 2
[parameters]
System action taken:
The change of attachment-point status is enabled or
disabled for the selected port immediately and is saved
in flash.
disabled for the selected port immediately and is saved
in flash.
System message display:
Change of attachment-point is set to
ENABLED/DISABLED