3com 7000 Manual Suplementario
Signaling Setup
205
Update Signaling
Protocol Version
Updates the signaling protocol version of the ports of the CoreBuilder
7000 family ATM switch.
7000 family ATM switch.
This command causes the new protocol version to be activated in the
current session. The new value is not stored in flash until you use the SAV
command (“Save Signaling Protocol Configuration” on page 206).
current session. The new value is not stored in flash until you use the SAV
command (“Save Signaling Protocol Configuration” on page 206).
If the new value of the protocol version is not stored in flash, the system
reverts to the previous value of the protocol version the next time it
reboots.
reverts to the previous value of the protocol version the next time it
reboots.
Command Actions
Command Result
Example
Enter:
1 1 4 5 4 3.2 1
The following message is displayed:
Parameter was set. Use 'SAVE' to save it on flash.
The signaling protocol version for port 3.2 is updated to 3.1.
Enter the menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(4) SIG: Signaling setup
(5) SPS: Signaling protocol setup
(4) SPV: Set protocol version
Enter a parameter at the prompt
Parameter
Format or Range
Port ID
slot.port (
0.0
for all ports)
Protocol version
0
for version 3.0
1
for version 3.1
2
for version 4.0
Direct access sequence:
1 1 4 5 4
[parameters]
System action taken:
The signaling protocol version is updated for the
specified port.
specified port.
System message display:
Parameter was set.