3com 7000 Manual Suplementario
216
C
HAPTER
7: C
ONFIGURING
V
IRTUAL
C
HANNELS
Display QSAAL
Signaling Timers and
SSCOP Configuration
Displays the current QSAAL signaling protocol timer values and SSCOP
configuration parameters for the specified port. The timer values are
displayed in tenths of a second.
configuration parameters for the specified port. The timer values are
displayed in tenths of a second.
You update the timer values by changing the timer resolution. For more
information, “Update Protocol Timer Resolution” on page 212. The
SSCOP configuration parameters cannot be altered by the normal admin
LMA menus. If you need to alter SSCOP configuration parameters,
contact your 3Com technical support.
information, “Update Protocol Timer Resolution” on page 212. The
SSCOP configuration parameters cannot be altered by the normal admin
LMA menus. If you need to alter SSCOP configuration parameters,
contact your 3Com technical support.
Command Actions
Command Result
Example
Enter:
1 1 4 4
3.2
The following information is displayed (1-9 are timers, 10-13 are
configuration parameters):
configuration parameters):
Enter the menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(4) SIG: Signaling setup
(4) QSA: Signaling QSAAL config
Enter a parameter at the prompt
Parameter
Format or Range
Port ID
slot.port
Direct access sequence:
1 1 4 4
[parameters]
System action taken:
The current QSAAL signaling protocol timer values and
SSCOP configuration parameters for the specified port
are displayed.
SSCOP configuration parameters for the specified port
are displayed.
System message display:
Information is displayed as shown in the example
below.
below.