3com 7000 Manual Suplementario
326
C
HAPTER
11: C
ONFIGURING
LAN E
MULATION
S
ERVERS
(LES)
AND
C
LIENTS
Update ELAN
Parameters in LES
Database
Updates the parameters for the specified ELAN in the LES database.
Table 48 describes the ELAN parameters you can update.
Table 48 describes the ELAN parameters you can update.
After you use this command to update the parameters of an ELAN in the
LES database you must use LMA to update the parameters of the ELAN in
the LECS database in exactly the same way (see “Update ELAN
Parameters in LECS Database” on page 293).
LES database you must use LMA to update the parameters of the ELAN in
the LECS database in exactly the same way (see “Update ELAN
Parameters in LECS Database” on page 293).
After updating the parameters, the ELAN is reset, that is, the control
distribute channel to all LECs attached to the ELAN is disconnected.
distribute channel to all LECs attached to the ELAN is disconnected.
Command Actions
Command Result
Example
Enter:
2 2 4 14 1 1
The following message appears:
ELAN is reset.
The parameters of the ELAN with ID 14 are updated.
Enter menu sequence:
(2) LEM: LAN Emulation
(2) LES: LE Services
(4) EFP: LES Edit ELANs Parameters
Enter a parameter at the prompt
Parameter
Format or Range
ELAN ID
1
–
16
ELAN type
1
-Ethernet
2
-Token ring (supported by CB7000 HD only
)
Elan max frame size
1
-1516
2
-4544
5
-1580
Direct access sequence:
2 2 4
[parameters]
System action taken:
The parameters for the specified ELAN are updated.
The update takes place immediately.
The update takes place immediately.
System message display:
ELAN is reset.