3com 7000 Manual Suplementario
Configuring PNNI Nodes
385
Set ATM Address
Updates the last six bytes (ESI - End System Identifier) of the ATM address
of the current node. A change to the ATM address takes place after the
next reboot. For more information on ATM addressing in PNNI, see “ATM Address Format” on page 84 in the Operations Guide.
of the current node. A change to the ATM address takes place after the
next reboot. For more information on ATM addressing in PNNI, see “ATM Address Format” on page 84 in the Operations Guide.
There are several PNNI operations in the LMA that can only be performed
when the node administrative status is set to DOWN, and that take effect
immediately after the status is reset to UP. These include updating the
ATM address, updating the PNNI node id and updating the node level.
when the node administrative status is set to DOWN, and that take effect
immediately after the status is reset to UP. These include updating the
ATM address, updating the PNNI node id and updating the node level.
Command Actions
Command Result
Example
Enter:
1 1 10 4 3 3 2 3 00.C0.DA.60.00.27
The following message is displayed:
New ESI of PNNI Node ATM Address was set, New ATM address is:
47.00.00.00.00.00.3C.00.00.00.00.00.00.00.C0.DA.60.00.27.FF
Enter menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(3) CHR: Characteristics
(2) ADD: ATM Address
(3) SAD: Set ATM Address
Enter a parameter at the prompt
Parameter
Format or Range
ESI address
xx.xx.xx.xx.xx.xx
where xx are two hex digits representing a single
byte.
byte.
Direct access sequence:
1 1 10 4 3 3 2 3
[parameters]
System action taken:
The ESI of the ATM address of the current node is
displayed and updated to its new value.
displayed and updated to its new value.
System message display:
New ESI of PNNI Node ATM Address was
set, New ATM address is: <address>