3com 7000 Manual Suplementario
Configuring PNNI Nodes
391
Set Node ID
Updates the ID of the PNNI node to a new address. A change to the node
lD takes place after the administrative status is set to UP or after the next
reboot. For more information, see “Set Node Administrative Status to
UP” on page 378.
lD takes place after the administrative status is set to UP or after the next
reboot. For more information, see “Set Node Administrative Status to
UP” on page 378.
There are several PNNI operations in the LMA that can only be performed
when the node administrative status is set to DOWN, and that take effect
immediately after the status is reset to UP. These include updating the
ATM address, updating the PNNI node id and updating the node level.
when the node administrative status is set to DOWN, and that take effect
immediately after the status is reset to UP. These include updating the
ATM address, updating the PNNI node id and updating the node level.
Command Actions
Command Result
Example
Enter:
1 1 10 4 3 3 4 3
47.00.00.00.00.00.3C.00.00.00.00.00.00.00.C0.DA.60.27.F6.F6
The following message is displayed:
New Node ID was set. Node Id:
47.00.00.00.00.00.3C.00.00.00.00.00.00.00.C0.DA.60.27.F6.F6
The node ID is updated to its new value.
Enter menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(3) CHR: Characteristics
(4) NID: Node ID
(3) SID: Set Node ID
Enter a parameter at the prompt
Parameter
Format or Range
node id
20 bytes
Direct access sequence:
1 1 10 4 3 3 4 3
System action taken:
The current PNNI node id is set to the new address.
System message display:
New Node ID was set. Node Id: