3com 7000 Manual Suplementario
456
C
HAPTER
13: C
ONFIGURING
AND
M
ANAGING
PNNI (F
OR
THE
E
XTENDED
V
ERSION
O
NLY
)
Display Node Address
Information
Displays all ATM addresses that are used for route calculation of each
node about which information is stored in the topology database.
node about which information is stored in the topology database.
Command Actions
Command Result
Node Address PTSE Table Parameters
For a full description of all the parameters displayed in the node address
information table, see Table 60: PTSE Table Parameters - Node Address
Section.
information table, see Table 60: PTSE Table Parameters - Node Address
Section.
Example
Enter:
1 1 10 4 7 5
Enter menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(7) SHO: Show PNNI information
(5) ADD: Address PTSEs
Direct access sequence:
1 1 10 4 7 5
System action taken:
The address information for each node in the
database is displayed.
database is displayed.
System message display:
Information is displayed as shown in the example.