3com 7000 Manual Suplementario
Downloading System Software and Configuration
49
Upload Configuration
Parameters
Stores configuration parameters by performing TFTP configuration upload
from flash memory to disk. Specify the Server IP address and file names. If
the single-IP mode is enabled, you can also use this command to upload
data from CoreBuilder 7X00 interface cards installed in the same chassis
(see “Enable/Disable Single-IP Mode” on page 85). For more information,
see “Storing and Retrieving Configuration Parameters” on page 75 in the Installation Guide.
from flash memory to disk. Specify the Server IP address and file names. If
the single-IP mode is enabled, you can also use this command to upload
data from CoreBuilder 7X00 interface cards installed in the same chassis
(see “Enable/Disable Single-IP Mode” on page 85). For more information,
see “Storing and Retrieving Configuration Parameters” on page 75 in the Installation Guide.
Command Actions
Command Result
Enter the menu sequence:
(1) SYS: Platform config
(3) LOA: Load system s/w / config
(6) TCU: Upload config from flash
to TFTP server
Enter a parameter at the prompt
Parameter
Format or Range
Select module
1–5
Select data type
1–9
Server IP address
IP address
Name of file on server
file name with path
Continue prompt
y
or
n
Direct access sequence:
1 3 6
[parameters]
System action taken:
The selected data of the selected module is uploaded
by TFTP to the server.
by TFTP to the server.
System message display:
Information is displayed as shown in the example.