3com 7000 Manual Suplementario
Setting Up for Management
71
Update IP Address
Enter the new IP address to update the IP address of the CoreBuilder
7000 family ATM switch. The default factory IP address is 0.0.0.0. The IP
address is changed after the next reboot of the switch.
7000 family ATM switch. The default factory IP address is 0.0.0.0. The IP
address is changed after the next reboot of the switch.
Run the integrated fast setup to configure this parameter.
Command Actions
Command Result
Example
Enter:
1 1 2 1 2 100.0.2.2
The IP address is updated to 100.0.2.2 after the next reboot.
It is essential to change the factory default IP address to match your
network addresses.
network addresses.
Enter the menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(2) MNG: Management setup
(1) SIP: IP Setup
(2) SIP: Set & Save IP Address
Enter a parameter at the prompt
Parameter
Format or Range
IP Address
valid IP address
Direct access sequence:
1 1 2 1 2
[parameters]
System action taken:
The IP address is updated after the next reboot of the
switch.
switch.
System message display:
Run integrated fast setup to configure
this parameter.
this parameter.