3com 140m Guía Del Usuario
Unit Pages
4-11
Unit Status
This page provides detailed information about the
unit:
unit:
System Name The name configured for the switch.
Contact The person to contact if there is a problem
with the network.
with the network.
Location Where the switch is located.
The Unit Name, Location and Contact can be
configured using pages in the Management Settings
category.
configured using pages in the Management Settings
category.
Hardware Version The version of hardware inside
the switch.
the switch.
MAC Address The switch’s MAC (Ethernet) address.
Software Version The version of management
software that the switch is running.
software that the switch is running.
Boot PROM Version The version of software on the
Boot PROM inside the switch.
Boot PROM inside the switch.
System Uptime The time that has elapsed since the
switch was last reset, initialized or powered on.
switch was last reset, initialized or powered on.
To display the Management Addresses page, click
IP Setup at the bottom of the Unit Status page.
IP Setup at the bottom of the Unit Status page.
Management Addresses
This page specifies a unique IP address for the
switch, as shown in
switch, as shown in
. The switch must have
IP configured correctly if you want to manage it over
the network.
the network.
If you have no previous knowledge of IP, refer to
. If you change any of these values, you
must reset the switch (refer to
and then re-access the switch using the new values.
Figure 4-8 Management Addresses Page