3com S7906E Instruccion De Instalación
1-17
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
interface-number
—
Enable the IGMP SSM
mapping feature
mapping feature
igmp ssm-mapping enable
Required
Disabled by default
To ensure SSM service for all hosts on a subnet, regardless of the IGMP version running on the hosts,
enable IGMPv3 on the interface that forwards multicast traffic onto the subnet.
Configuring SSM Mappings
By performing this configuration multiple times, you can map a multicast group to different multicast
sources.
Follow these steps to configure an IGMP SSM mapping:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter public instance or
VPN instance IGMP view
VPN instance IGMP view
igmp [ vpn-instance
vpn-instance-name ]
vpn-instance-name ]
—
Configure an IGMP SSM
mapping
mapping
ssm-mapping group-address
{ mask | mask-length }
source-address
{ mask | mask-length }
source-address
Required
No IGMP mappings are
configured by default.
configured by default.
If IGMPv3 is enabled on a VLAN interface, and if a port in that VLAN is configured as a simulated host,
the simulated host will send IGMPv3 reports even if you did not specify a multicast source when
configuring simulated joining with the igmp-snooping host-join command. In this case, the
corresponding multicast group will not be created based on the configured IGMP SSM mappings. For
details about the igmp-snooping host-join command, refer to IGMP Snooping Commands in the IP
Multicast Volume.
Configuring IGMP Proxying
Configuration Prerequisites
Before configuring the IGMP proxying feature, complete the following tasks: