3com S7906E Instruccion De Instalación

 

1-6 

Enter system view 

— 

Enable the SSH server function  ssh server enable 

Required 

Disabled by default 

 

An SSH client accesses the device through a VTY user interface. Therefore, you need to configure the 

user interfaces for SSH clients to allow SSH login. Note that the configuration takes effect only for 

clients logging in after the configuration. 

Follow these steps to configure the protocols for the current user interface to support: 

Enter system view 

— 

Enter user interface view of one 
or more user interfaces 

user-interface vty number 
[ ending-number ] 

— 

Set the login authentication 
mode to scheme 

authentication-mode scheme 

Required 

By default, the authentication 
mode is password.  

Configure the user interface(s) 
to support SSH login 

protocol inbound { all | ssh } 

Optional 

All protocols are supported by 
default. 

 

z 

For detailed information about the authentication-mode and protocol inbound commands, refer 

to User Interface Commands of the System Volume. 

z 

If you configure a user interface to support SSH, be sure to configure the corresponding 

authentication method with the authentication-mode scheme command.  

z 

For a user interface configured to support SSH, you cannot change the authentication mode. To 

change the authentication mode, undo the SSH support configuration first. 

 

 

This configuration task is only necessary for SSH users using publickey authentication.  

 

For each SSH user that uses publickey authentication to login, you must configure the client’s DSA or 

RSA host public key on the server, and configure the client to use the corresponding private key.