3com S7906E Instruccion De Instalación

 

1-2 

 

Before assigning a port to a monitor link group, make sure the port is not the member port of any 

aggregation group or service loopback group.  

Follow these steps to configure monitor link: 

Enter system view 

— 

Create a monitor link group and enter 
monitor link group view 

monitor-link group group-id 

Required 

In monitor link 
group view 

port interface-type 
interface-number uplink 

Configure the 
uplink for the 
monitor link group 

In Ethernet port 
view or Layer 2 
aggregate 
interface view 

port monitor-link group 
group-id uplink 

Use either approach 

Repeat this step to 
add more uplink ports

In monitor link 
group view 

port interface-type 
interface-number downlink 

Configure the 
downlink for the 
monitor link group 

In Ethernet port 
view or Layer 2 
aggregate 
interface view 

port monitor-link group 
group-id downlink 

Use either approach 

Repeat this step to 
add more downlink 
ports 

 

z 

A port can be assigned to only one monitor link group.  

z 

You are recommended to configure uplink ports prior to downlink ports, thus avoiding undesired 

down/up state changes on the downlink ports.  

 

GigabitEthernet 2/0/1 and GigabitEthernet 2/0/2 of a device are up. Configure GigabitEthernet 2/0/2 to 

change its up/down state as GigabitEthernet 2/0/1.  

Configuration procedure 

<Sysname> system-view 

[Sysname] monitor-link group 1 

[Sysname-mtlk-group1] port gigabitethernet 2/0/1 uplink