3com S7906E Instruccion De Instalación

 

1-26 

[DeviceE-GigabitEthernet2/0/1] port trunk permit vlan all 

[DeviceE-GigabitEthernet2/0/1] quit 

[DeviceE] interface gigabitethernet 2/0/2 

[DeviceE-GigabitEthernet2/0/2] link-delay 0 

[DeviceE-GigabitEthernet2/0/2] undo stp enable 

[DeviceE-GigabitEthernet2/0/2] port link-type trunk 

[DeviceE-GigabitEthernet2/0/2] port trunk permit vlan all 

[DeviceE-GigabitEthernet2/0/2] quit 

# Create RRPP domain 1, configure VLAN 4092 as the primary control VLAN of RRPP domain 1, and 

configure VLANs mapped to MSTIs 0 through 31 as the protected VLANs of RRPP domain 1.  

[DeviceE] rrpp domain 1 

[DeviceE-rrpp-domain1] control-vlan 4092 

[DeviceE-rrpp-domain1] protected-vlan reference-instance 0 to 31 

# Configure Device E as the master node of subring 2, with GigabitEthernet 2/0/1 as the primary port 

and GigabitEthernet 2/0/2 as the secondary port, and enable ring 2.  

[DeviceE-rrpp-domain1] ring 2 node-mode master primary-port gigabitethernet 2/0/1 

secondary-port gigabitethernet 2/0/2 level 1 

[DeviceE-rrpp-domain1] ring 2 enable 

[DeviceE-rrpp-domain1] quit 

# Enable RRPP.  

[DeviceE] rrpp enable 

6) Verification 

After the configuration, you can use the display command to view RRPP configuration and operational 

information on each device. 

z 

Device A, Device B, Device C, Device D, and Device F constitute RRPP domain 1, and VLAN 100 

is the primary control VLAN of the RRPP domain. Device A is the master node of the primary ring 

Ring 1; Device D is the transit node of the primary ring Ring 1; Device F is the master node of the 

subring Ring 3; Device C is the edge node of the subring Ring 3; Device B is the assistant-edge 

node of the subring Ring 3.  

z 

Device A, Device B, Device C, Device D, and Device E constitute RRPP domain 2, and VLAN 105 

is the primary control VLAN of the RRPP domain. Device A is the master node of the primary ring 

Ring 1; Device D is the transit node of the primary ring Ring 1; Device E is the master node of the 

subring Ring 2; Device C is the edge node of the subring Ring 2; Device B is the assistant-edge 

node of the subring Ring 2.  

z 

Specify VLAN 10 as the protected VLAN of domain 1, and VLAN 20 as the protected VLAN of 

domain 2. Thus, you can achieve VLAN-based load balancing on the primary ring.  

z 

As the edge node and assistant-edge node of subring Ring 2 is the same as those of subring Ring 

3, and the two subrings have the same SRPTs, you can add subrings Ring 2 and Ring 3 to the 

RRPP ring group to reduce Edge-Hello traffic.