3com S7906E Instruccion De Instalación

 

1-12 

z 

Configure an MA in each MD 

z 

Configure a service instance for each MA 

Figure 1-5 Network diagram for MD configuration 

 

 

1)  Configuration on Device A (configuration on Device E is the same as that on Device A) 

<DeviceA> system-view 

[DeviceA] cfd enable 

[DeviceA] cfd md MD_A level 5 

[DeviceA] cfd ma MA_MD_A md MD_A vlan 100 

[DeviceA] cfd service-instance 1 md MD_A ma MA_MD_A 

2)  Configuration on Device C 

<DeviceC> system-view 

[DeviceC] cfd enable 

[DeviceC] cfd md MD_B level 3 

[DeviceC] cfd ma MA_MD_B md MD_B vlan 100 

[DeviceC] cfd service-instance 2 md MD_B ma MA_MD_B 

3)  Configuration on Device B (configuration on Device D is the same as that on Device B) 

<DeviceB> system-view 

[DeviceB] cfd enable 

[DeviceB] cfd md MD_A level 5 

[DeviceB] cfd ma MA_MD_A md MD_A vlan 100 

[DeviceB] cfd service-instance 1 md MD_A ma MA_MD_A 

[DeviceB] cfd md MD_B level 3 

[DeviceB] cfd ma MA_MD_B md MD_B vlan 100 

[DeviceB] cfd service-instance 2 md MD_B ma MA_MD_B 

After the above configuration, you can use the commands display cfd md,  display cfd ma and 

display cfd service-instance to verify your configuration. 

After finishing service instance configuration, you can start to design the MEPs. 

z 

MEPs are configured at the edge or border of MDs. Find the edge port of each MD.