3com S7906E Instruccion De Instalación

 

1-15 

Figure 1-7 Network diagram of MD and MP configuration 

 

 

1)  Configure Device B 

<DeviceB> system-view 

[DeviceB] cfd mip-rule explicit service-instance 1 

2)  Configure Device C 

<DeviceC> system-view 

[DeviceC] cfd mip-rule default service-instance 2 

After the above operation, you can use the display cfd mp command to verify your configuration. 

Use the LB function to trace the fault source after CC detects a link fault. 

As shown in 

, enable LB on Device A so that Device A can send LBM messages to MEPs on 

Device D. 

# Configure Device A 

<DeviceA> system-view 

[DeviceA] cfd loopback service-instance 1 mep 1001 target-mep 4002 

Use the LT function to find the path and locate the fault after you obtain the state of the entire network 

through the CC. 

As shown in 

, enable LT on Device A so that Device A can send LTM messages to the MEP on 

Device D. 

# Configure Device A 

<DeviceA> system-view