3com S7906E Instruccion De Instalación

 

1-10 

# Configure the IP address of the agent as 1.1.1.1/24 and make sure that there is a route between the 

agent and the NMS. (The configuration procedure is omitted here) 

# Configure the SNMP basic information, including the version and community name. 

<Sysname> system-view 

[Sysname] snmp-agent sys-info version v1 v2c 

[Sysname] snmp-agent community read public 

[Sysname] snmp-agent community write private 

# Configure the contact person and physical location information of the switch. 

[Sysname] snmp-agent sys-info contact Mr.Wang-Tel:3306 

[Sysname] snmp-agent sys-info location telephone-closet,3rd-floor 

# Enable the sending of traps to the NMS with an IP address of 1.1.1.2/24, using public as the 

community name. 

[Sysname] snmp-agent trap enable 

[Sysname] snmp-agent target-host trap address udp-domain 1.1.1.2 udp-port 5000 params 

securityname public v1 

Ensure that the SNMP version specified in the snmp-agent target-host command is the same with that 

on the NMS; otherwise, the NMS cannot receive any trap. 

2)  Configuring the SNMP NMS 

With SNMPv1/v2c, the user needs to specify the read only community, the read and write community, 

the timeout time, and number of retries. The user can inquire and configure the device through the 

NMS. 

 

The configurations on the agent and the NMS must match. 

 

3)  Verify the configuration 

z 

After the above configuration, an SNMP connection is established between the NMS and the agent. 

The NMS can get and configure the values of some parameters on the agent through MIB nodes. 

z 

Execute the shutdown or undo shutdown command to an idle interface on the agent, and the 

NMS receives the corresponding trap. 

z 

As shown in 

, the NMS connects to the agent through an Ethernet. 

z 

The IP address of the NMS is 1.1.1.2/24. 

z 

The IP address of the agent is 1.1.1.1/24. 

z 

The NMS monitors and manages the interface status of the agent using SNMPv3. The agent 

reports errors or faults to the NMS. The inbound port for traps on the NMS is 5000.