3com S7906E Instruccion De Instalación

 

1-2 

z 

For a low-speed network, you are recommended to set a larger value for the timeout timer 

(indicated by the -t parameter in the command) when configuring the ping command. 

z 

Only the directly connected segment address can be pinged if the outgoing interface is specified 

with the -i argument 

z 

For detailed description of the ping lsp command, refer to MPLS Basics Commands in the MPLS 

Volume. 

 

As shown in 

, check whether an available route exists between Device A and Device C. If 

there is an available route exists between the two devices, get the detailed information of routes from 

Device A to Device C. 

Figure 1-1 Ping network diagram 

 

 

 

# Use the ping command to display whether an available route exists between Device A and Device C. 

<DeviceA> ping 1.1.2.2 

  PING 1.1.2.2: 56  data bytes, press CTRL_C to break 

    Reply from 1.1.2.2: bytes=56 Sequence=1 ttl=254 time=205 ms 

    Reply from 1.1.2.2: bytes=56 Sequence=2 ttl=254 time=1 ms 

    Reply from 1.1.2.2: bytes=56 Sequence=3 ttl=254 time=1 ms 

    Reply from 1.1.2.2: bytes=56 Sequence=4 ttl=254 time=1 ms 

    Reply from 1.1.2.2: bytes=56 Sequence=5 ttl=254 time=1 ms 

 

  --- 1.1.2.2 ping statistics --- 

    5 packet(s) transmitted 

    5 packet(s) received 

    0.00% packet loss 

round-trip min/avg/max = 1/41/205 ms 

# Get the detailed information of routes from Device A to Device C.