3com S7906E Instruccion De Instalación
1-18
To do…
Use the command…
Remarks
Specify a RIP neighbor
peer ip-address
Required
By default, RIP does not
unicast updates to any peer.
unicast updates to any peer.
Enter interface view
interface interface-type
interface-number
interface-number
—
Enable BFD on the RIP
interface
interface
rip bfd enable
Required
Disabled by default
z
Unidirectional detection in BFD echo packet mode only works for RIP neighbors that are directly
connected, namely, one hop away from each other.
z
Using the undo peer command does not remove the neighbor relationship at once and therefore
cannot bring down the BFD session at once.
Displaying and Maintaining RIP
To do…
Use the command…
Remarks
Display RIP current status and
configuration information
configuration information
display rip [ process-id |
vpn-instance
vpn-instance-name ]
vpn-instance
vpn-instance-name ]
Display all active routes in RIP
database
database
display rip process-id
database
database
Display RIP interface
information
information
display rip process-id
interface [ interface-type
interface-number ]
interface [ interface-type
interface-number ]
Display routing information
about a specified RIP process
about a specified RIP process
display rip process-id route
[ ip-address { mask |
mask-length } | peer ip-address
| statistics ]
[ ip-address { mask |
mask-length } | peer ip-address
| statistics ]
Available in any view
Reset a RIP process
reset rip process-id process
Clear the statistics of a RIP
process
process
reset rip process-id statistics
Available in user view
RIP Configuration Examples
Configuring RIP Version
Network requirements
As shown in
, enable RIPv2 on all interfaces on Switch A and Switch B.