3com S7906E Instruccion De Instalación

 

1-29 

Configure the OSPF network 
type for the interface as P2MP 

ospf network-type p2mp 
[ unicast ] 

Required 

By default, the network type of an 
interface depends on the link 
layer protocol.  

After you configure the OSPF 
network type for an interface as 
P2MP unicast, all packets are 
unicast over the interface. Thus 
the interface cannot broadcast 
hello packets to discover 
neighbors. In that case, you need 
to manually specify the IP 
address of the neighboring 
interface.  

Exit to system view 

— 

Enter OSPF view 

ospf [ process-id | router-id 
router-id | vpn-instance 
instance-name ] * 

— 

Specify a neighbor and its DR 
priority on a P2MP unicast 
network 

peer ip-address [ cost value | 
dr-priority dr-priority ] 

Required if the interface type is 
P2MP unicast 

 

Follow these steps to configure the OSPF network type for an interface as P2P: 

Enter system view 

— 

Enter interface view 

interface interface-type 
interface-number 

— 

Configure the OSPF network 
type for the interface as P2P 

Required 

By default, the network type of an 
interface depends on the link 
layer protocol. 

 

This section covers how to control OSPF routing information advertisement and reception, and route 

redistribution from other protocols.  

Before configuring this task, you have configured: 

z 

IP addresses for interfaces 

z 

OSPF basic functions 

z 

Corresponding filters if routing information filtering is needed.