3com 3031 Instruccion De Instalación
Ethernet Interface
129
Selecting an operating mode for the FE interface
As mentioned earlier, an Ethernet interface can work at both full-duplex mode and
half-duplex mode. Connected to a hub, the Ethernet interface on a router must be
specified to work in half-duplex mode. Connected to a LAN Switch, however, it
must be specified to work in full-duplex mode. Perform the following
configuration in Ethernet interface view to select an operating mode.
half-duplex mode. Connected to a hub, the Ethernet interface on a router must be
specified to work in half-duplex mode. Connected to a LAN Switch, however, it
must be specified to work in full-duplex mode. Perform the following
configuration in Ethernet interface view to select an operating mode.
By default,
negotiation
is selected, i.e., the system automatically chooses an
optimum operating mode.
Enabling or disabling loopback
Sometimes, you need to enable local loop on an interface for the purpose of
testing some special functions. Perform the following configuration in Ethernet
interface view to enable an interface to make local loop.
testing some special functions. Perform the following configuration in Ethernet
interface view to enable an interface to make local loop.
By default, local loop is disabled.
Displaying and
Debugging Ethernet
Interface
Perform the following configuration in any view.
Ethernet Configuration
Example
Networking requirements
As shown in the following figure, the Ethernet interface on Router A is connected
to the IP network 192.168.0.0. The computers on the LAN are connected to the
Internet via Router A. Set the MTU on the Ethernet interface to 1492 bytes.
to the IP network 192.168.0.0. The computers on the LAN are connected to the
Internet via Router A. Set the MTU on the Ethernet interface to 1492 bytes.
Networking diagram
Figure 30 Networking diagram of Ethernet configuration example
Table 139 Selecting an operating mode for the FE interface
Operation
Command
Select an operating mode for the FE
interface
interface
duplex { negotiation | full | half }
Table 140 Enabling or disabling local loop
Operation
Command
Enable local loop
loopback
Disable local loop
undo loopback
Table 141 Displaying the state of a specified Ethernet interface
Operation
Command
Display the state of a specified Ethernet
interface
interface
display interfaces ethernet number
Internet
Interface Address
192.168.0.1
E0
LAN
Router A
Network Address
192.168.0.0