3com 3031 Instruccion De Instalación

C

HAPTER

 14: WAN I

NTERFACE

 C

ONFIGURATION

Perform the following configuration in AUX interface view.

The link setup mode defaults to flow mode.

If the AUX interface has been disabled to make level detection, the system will 
only detect whether the interface is connected to an external cable and then 
report the interface state (UP or DOWN) to the user. If the interface has been 
enabled to make level detection, the system will detect the DSR(Data Set Ready) 
signal in addition to the external cable. The interface will be regarded UP only if 
the detected DSR signal is valid. Otherwise, it will be regarded DOWN.

Perform the following configuration in AUX interface view.

By default, level detection is enabled.

You may enable the AUX interface to make local loop for the purpose of testing 
some special functions.

Perform the following configuration in AUX interface view.

By default, local loop is disabled.

Perform the following configuration in AUX interface view.

Table 151   Setting a link setup mode on an AUX interface

Configure the AUX interface to set up links with the protocol 
approach

Configure the AUX interface to set up links with the flow 
approach

Table 152   Setting the level detection function on the AUX interface

Enable the AUX interface to make level detection

Disable the AUX interface to make level detection

Table 153   Enabling/Disabling the AUX interface to make local loop

Enable the AUX interface to make local loop

Disable the AUX interface to make local loop

Table 154   Setting the link layer protocol of the AUX interface

Set the link layer protocol of the AUX interface to PPP