3com 3031 Instruccion De Instalación
CT1/PRI Interface
153
The major configuration tasks include:
■
Configure DCC operating parameters
■
Encapsulate the link layer protocol PPP and configure its authentication
parameters, etc
parameters, etc
■
Configure IP address
■
Configure the operating parameters of backup center if the interface will work
as the master interface or the standby interface in the backup center
as the master interface or the standby interface in the backup center
■
Configure address translation and packet filtering rules if a firewall should be
set up on the interface
set up on the interface
Refer to the related sections in this manual for details.
Setting length/attenuation of the transmission cable
To guarantee the signal quality at the receiving end, you should set proper signal
attenuation and waveform on the CT1/PRI interface depending on the length of
the transmission cable to which the interface is connected.
attenuation and waveform on the CT1/PRI interface depending on the length of
the transmission cable to which the interface is connected.
Perform the following configuration in CT1/PRI interface view.
By default, the attenuation of transmission cable that the CT1/PRI interface
matches is
matches is
long 0db
.
Setting line code format
CT1/PRI interfaces support two types of line code formats, namely, ami and b8zs.
Perform the following configuration in CT1/PRI interface view.
The line code format on CT1/PRI interfaces defaults to
b8zs
.
Setting line clock
When a CT1/PRI interface is working as DCE, chose the internal clock for it, that is,
master
clock mode. When it is working as DTE, chose the line clock, that is,
slave
clock mode for it.
Table 186 Setting length/attenuation of the transmission cable on the CT1/PRI interface
Operation
Command
Set the CT1/PRI interface to use the
long-distance transmission cable
long-distance transmission cable
cable long { 0db | -7.5db | -15db |
-22.5db }
-22.5db }
Set the CT1/PRI interface to use the
short-distance transmission cable
short-distance transmission cable
cable short { 133ft | 266ft | 399ft |
533ft | 655ft }
533ft | 655ft }
Restore the default setting of the
transmission cable used by the
CT1/PRI interface
transmission cable used by the
CT1/PRI interface
undo cable
Table 187 Setting the line code format on the CT1/PRI interface
Operation
Command
Set the line code format on the CT1/PRI interface
code { ami | b8zs }
Restore the default line code format on the CE1/PRI interface
undo code