3com 3031 Instruccion De Instalación
168
C
HAPTER
14: WAN I
NTERFACE
C
ONFIGURATION
Setting frame format on the CT3 interface
Perform the following configuration in CT3 interface view.
By default, the CT3 interface uses the C-bit frame format.
When the CT3 interface is working in channelized mode, the frame format of T1
line can be set.
line can be set.
Perform the following configuration in CT3 interface view.
By default, T1 lines use ESF.
Setting operating mode of the CT3 interface
Perform the following configuration in CT3 interface view.
By default, the CT3 interface works in channelized mode.
When the CT3 interface is working in unchannelized mode, the system
automatically creates a serial interface numbered
automatically creates a serial interface numbered
serial number / 0:0
for it.
This interface operates at 44.736 Mbps and has the same logic features of a
synchronous serial interface on which you can make other configurations.
synchronous serial interface on which you can make other configurations.
When the CT3 interface is working in channelized mode, you can demultiplex it
into 28 T1 lines at 1.544 Mbps and set their operating modes separately.
into 28 T1 lines at 1.544 Mbps and set their operating modes separately.
Table 225 Configuring a frame format on the CT3 interface
Operation
Command
Configure a frame format on the CT3 interface
frame-format { c-bit | m23 }
Restore the default setting on the CT3 interface
undo frame-format
Table 226 Configuring a frame format for a T1 line
Operation
Command
Configure a frame format for a
T1 line
T1 line
t1 line-number set frame-format { esf | sf }
Restore the default frame
format
format
undo t1 line-number set frame-format
Table 227 Setting operating mode of the CT3 interface
Operation
Command
Set operating mode of the CT3 interface
using { t3 | ct3 }
Restore the default setting
undo using
Table 228 Setting operating mode of a T1 line
Operation
Command
Set a T1 line on the CT3 interface
to work in T1 (unframed) mode.
to work in T1 (unframed) mode.
t1 line-number unframed
Set a T1 line on the CT3 interface
to work in CT1 (framed) mode.
to work in CT1 (framed) mode.
undo t1 line-number unframed
Bundle the timeslots on the CT1
line
line
t1 line-number channel-set set-number
timeslot-list range [ speed { 56k | 64k } ]
timeslot-list range [ speed { 56k | 64k } ]