3com 3031 Instruccion De Instalación
Configuring PPP
195
using the NCP parameters (such as IP address) in the virtual-template. In this case,
the NCP parameters configured on the physical interface will take no effect. If NCP
negotiation is successful, the interface can set up an MP link that can provide a
wider bandwidth for data transfer.
the NCP parameters configured on the physical interface will take no effect. If NCP
negotiation is successful, the interface can set up an MP link that can provide a
wider bandwidth for data transfer.
Directly binding without endpoint discriminator and user name
1 First, the interface begins the LCP negotiation with the peer in normal LCP
parameters in addition to verifying whether the peer interface is working in MP
mode. The authentication process may be taken if the authentication parameter is
set.
mode. The authentication process may be taken if the authentication parameter is
set.
2 If learning that the peer is not working in MP mode during the LCP negotiation,
the interface will go down. Otherwise, it will attempt to perform the NCP
negotiation using the NCP parameters (such as IP address) in the virtual-template.
In this case, the NCP parameters configured on the physical interface will take no
effect. If NCP negotiation is successful, the interface can set up an MP link that
can provide a wider bandwidth for data transfer.
negotiation using the NCP parameters (such as IP address) in the virtual-template.
In this case, the NCP parameters configured on the physical interface will take no
effect. If NCP negotiation is successful, the interface can set up an MP link that
can provide a wider bandwidth for data transfer.
MP channel can also be bind to MP-group interface, a logical interface with a
three dimension index name. MP-group interface owns all such characteristics as
shutdown, undo shutdown, interface backup, flow control, but baud rate setting.
See also the MP configuration section in this manual for more detail.
three dimension index name. MP-group interface owns all such characteristics as
shutdown, undo shutdown, interface backup, flow control, but baud rate setting.
See also the MP configuration section in this manual for more detail.
Configuring PPP
Fundamental PPP configuration tasks include:
■
Configure the data link protocol encapsulated on the interface to be PPP
■
Configure PPP authentication mode, user name and user password
■
Configure AAA authentication and accounting parameters of PPP
Advanced PPP configuration tasks include:
■
Configure PPP negotiation parameters
■
Configure PPP compression algorithm
The fundamental configuration is the parameter setting that must be performed
for running PPP on the router, whereas the advanced configurations are the
options that can be configured as needed.
for running PPP on the router, whereas the advanced configurations are the
options that can be configured as needed.
Configuring PPP
Encapsulation on the
Interface
Perform the following configuration in interface view.
The
link-protocol ppp
command can configure PPP as the link layer protocol
encapsulated on the interface.
The link layer protocol encapsulated on the interface defaults to PPP.
Table 254 Configuring PPP encapsulation on the interface
Operation
Command
Configure PPP encapsulation on the interface
link-protocol ppp