3com 3031 Instruccion De Instalación
![3com](https://files.manualsbrain.com/attachments/960452ff43b9899cbcffced60c87abf956e7967a/common/fit/150/50/f6ac125d7af2cf40fec58935fa6d4bf71457a57efe50bee91208a434f325/brand_logo.jpeg)
198
C
HAPTER
17: PPP
AND
MP C
ONFIGURATION
■
scheme-name
: the scheme list name.
■
method
: the authentication method which can be radius, local, or none.
■
server-group-name
: the name of the server group.
For PPP authentication method of AAA, refer to Chapter 57 “AAA and RADIUS
Configuration”. If PPP authentication method of AAA is not specified on the
interface, please use the default authentication method.
Configuration”. If PPP authentication method of AAA is not specified on the
interface, please use the default authentication method.
You finish the fundamental PPP configurations after performing the tasks
described in Sections 1.2.2 through 1.2.4 and can proceed to Section 1.2.5 to
start configuring the optional PPP parameters.
described in Sections 1.2.2 through 1.2.4 and can proceed to Section 1.2.5 to
start configuring the optional PPP parameters.
By default, PPP accounting is disabled.
Configuring PPP
Negotiation Parameters
The following PPP negotiation parameters can be configured:
Time interval between negotiation timeout During PPP negotiation, if the response
message of the peer is not received within this time interval, PPP will retransmit
the message. The timeout interval ranges from 1 to 10 seconds.
message of the peer is not received within this time interval, PPP will retransmit
the message. The timeout interval ranges from 1 to 10 seconds.
For some negotiation parameters of NCP such as the configuration of local IP
address and the IP address assigned to the peer, refer to Part V “Network
Protocol”. For example, the
address and the IP address assigned to the peer, refer to Part V “Network
Protocol”. For example, the
ip address ppp-negotiate
command can be used
to ask the peer to assign IP address for the local, while the
remote-address
command can be used to designate the local to assign IP address for the peer.
Perform the following configuration in interface view.
By default, the timeout interval is 3 seconds.
Negotiating IP address using PPP
1 Configure client
Suppose PPP has been encapsulated on local and remote interfaces. If the local
interface has no IP address while the remote interface has one, you may configure
the local interface to allow it to negotiate an IP address using PPP and accept the
interface has no IP address while the remote interface has one, you may configure
the local interface to allow it to negotiate an IP address using PPP and accept the
Configure PPP authentication
method of AAA at the interface
method of AAA at the interface
ppp authentication-mode { chap | pap } [
call-in ] [ scheme { default |
scheme-name } ]
call-in ] [ scheme { default |
scheme-name } ]
Configure a PPP accounting scheme
list on the interface. RADIUS
accounting is also supported.
list on the interface. RADIUS
accounting is also supported.
ppp accounting scheme { default |
scheme-name }
scheme-name }
Cancel accounting of PPP user at the
interface
interface
undo ppp accounting
Table 260 Configuring AAA authentication and accounting of PPP
Table 261 Configuring the time interval of PPP negotiation timeout
Operation
Command
Configure the time interval of negotiation timeout
ppp timer negotiate seconds
Restore the default value of time interval of
negotiation timeout
negotiation timeout
undo ppp timer negotiate