3com 3031 Instruccion De Instalación
284
C
HAPTER
25: ATM C
ONFIGURATION
[RouterA-Dialer0]dialer bundle 12
d Create VE port:
[RouterA]interface Virtual-Ethernet0
e Configure the atm port of adsl card:
[RouterA]interface Atm1/0
[RouterA-Atm1/0]pvc 0/32
[RouterA-atm-pvc-Atm1/0-0/32]map bridge vrtual-ethernet0
0011-0022-0030
f
Configure VE port:
[RouterA]interface virtual-ethernet0
[RouterA-Virtual-Ethernet0]pppoe-client dial-bundle-number 12
g Configure the default route:
[RouterA]ip route-static 0.0.0.0 0.0.0.0 Dialer 0
If PPPoEoA Server is 3Com router, PPPoEoA can be configured as follow:
local-user 3Com password simple hello
local-user 3Com service-type ppp
ip pool 80 10.1.1.2 10.1.1.100
interface Virtual-Template0
ppp authentication-mode chap
ppp chap user 3Com
ip address 10.1.1.1 255.255.0.0
remote-address pool 80
interface Atm7/0
pvc 0/32
map bridge Virtual-Ethernet0 0022-0022-00C1
interface Virtual-Ethernet0
pppoe-server bind Virtual-Template 0
ATM Fault Diagnosis
and Troubleshooting
and Troubleshooting
Fault 1: When IPoA is used, the link does not report 'UP'.
Problem solving: Possible reasons are as follows:
■
Check whether the optical fiber is plugged in correctly.
■
Check whether the local IP address has been configured.
■
Other reasons might be failure of PVC configuration or failure of
communication between cards.
communication between cards.
Fault 2: When PPPoA is used, the link does not report 'UP'.
Problem solving: Refer to Fault 1 problem solving.
Fault 3: Both Physical Layer and Line Protocol remain “UP”, but they are mutually
unreachable with
unreachable with
ping
command.
Problem solving:
■
When IPOA is used, check whether the IP protocol address mapping is
configured correctly. If the interfaces of two routers are directly connected, the
local PVC mapped to the peer IP must have the same (VPI, VCI) value as the
configured correctly. If the interfaces of two routers are directly connected, the
local PVC mapped to the peer IP must have the same (VPI, VCI) value as the