3com 3031 Instruccion De Instalación
Configure bridging function
345
Configure static address table entries
Normally, a bridging table is dynamically generated according to the correlation
between the MAC addresses and the ports obtained by the bridge. However, there
are still some static entries in the bridging address table, which are manually
configured and maintained by the administrators and will not age forever.
between the MAC addresses and the ports obtained by the bridge. However, there
are still some static entries in the bridging address table, which are manually
configured and maintained by the administrators and will not age forever.
Perform the following configuration in system view.
Table 394 Configure static address table entries
By default, dynamic address table is adopted to forward frames.
Enable/Disable forwarding by using dynamic address table
Perform the following configuration in system view.
Table 395 Enable/Disable forwarding by using dynamic address table
By default, the dynamic address table is used to forward frames.
Activate the Bridging
Function of Network
Bridge Protoco
l
Perform the following configuration in system view.
Table 396 Activate the bridging function of network bridge protocol
By default, bridging function is enabled.
Create ACLs of bridge
This operation involves the creation of an ACL based on Ethernet MAC addresses.
Perform the following configuration in system view (for the command
acl
) and
ACL view (for the command
rule
).
Table 397 Create an ACL based on Ethernet MAC addresses
Operation
Command
Configure static
address table entries
address table entries
bridge bridge-set mac-address mac-address { deny |
permit } [ interface interface-type interface-number
| dlsw ] [ dynamic | static ]
Delete static address
table entries
table entries
undo bridge bridge-set mac-address mac-address [
interface interface-type interface-number | dlsw ]
Operation
Command
Enable forwarding using the dynamic address
table
table
bridge bridge-set learning
Disable forwarding using the dynamic address
table
table
undo bridge bridge-set learning
Operation
Command
Activate the bridging function of
network bridge protocol
network bridge protocol
bridge bridge-set bridging { ip | ipx
}
Disable the bridging function of
network bridge protocol
network bridge protocol
undo bridge bridge-set bridging { ip | ipx
}
Operation
Command
Create an ACL and enter ACL
view
view
acl { number acl-number | name acl-name
ethernet-frame }
Delete an ACL
undo acl { acl-number | acl-name | all }