3com 3031 Instruccion De Instalación

C

HAPTER

 35: IPX C

ONFIGURATION

By default, IPX function is disabled.

If no node value of a router is specified when activating IPX function, the router 
will use the MAC address of its first Ethernet interface as its node address.

After activating the IPX function of a router, each independent interface must be 
assigned with a network ID so that IPX can run on the interface.

Perform the following configuration in interface view.

By default, IPX is disabled on all interfaces after being started.

If an IPX interface is deleted, the IPX configuration and static routing information 
of the interface will be deleted.

Perform the following in the System View.

The IPX static route with destination network ID -2 (0xFFFFFFFE) is the default 
route.

On configuring the two parameters ticks and hops, the both are configured or 
neither is configured, rather than only one is configured. A tick is 1/18 second.

In the implementation at present, the outgoing interface can only be encapsulated 
with PPP.

In IPX, the maximum dynamic route number and equivalent route number to the 
same destination address permitted in the routing table can be configured. The 
two configurations have no direct connection mutually, so changing one of the 
configurations will not affect the other.

Perform the following in the System View.

Table 475   Activating IPX

Activate IPX

ipx enable [ node node ]

Deactivate IPX

Table 476   Enabling IPX interface

Enable IPX interface

Delete IPX interface

Table 477   Configuring IPX static routes

Configure IPX 
static routes

px route-static network [ network.node | 

interface-type interface-num | interface-name ] [  
preference value ] [ tick ticks hop hops ]

Delete IPX static 
routes

undo ipx route-static { network [ network.node | 
interface-type interface-num | interface-name ] | all }