3com 3031 Instruccion De Instalación
![3com](https://files.manualsbrain.com/attachments/960452ff43b9899cbcffced60c87abf956e7967a/common/fit/150/50/f6ac125d7af2cf40fec58935fa6d4bf71457a57efe50bee91208a434f325/brand_logo.jpeg)
480
C
HAPTER
39: RIP C
ONFIGURATION
Configuring RIP to filter the imported routes
By default, RIP will not filter the received and imported routing information.
For more information, refer to the “Configuring Route Filtering” in Chapter 43 “IP
Routing Policy Configuration”.
Routing Policy Configuration”.
Disabling Host Route
In some special cases, the router can receive a lot of host routes from the same
segment, and these routes are of little help in route addressing but consume a lot
of network resources. After host route is disabled, a router can refuse a host route
it receives.
segment, and these routes are of little help in route addressing but consume a lot
of network resources. After host route is disabled, a router can refuse a host route
it receives.
Perform the following in the RIP View.
By default, the router receives the host route.
Configuring Route
Aggregation
The so-called route aggregation means that different subnet routes in the same
natural network can be aggregated into one natural mask route for transmission
when they are sent to the outside (i.e. other network). Route aggregation can be
performed to reduce the routing traffic on the network as well as to reduce the
size of the routing table.
natural network can be aggregated into one natural mask route for transmission
when they are sent to the outside (i.e. other network). Route aggregation can be
performed to reduce the routing traffic on the network as well as to reduce the
size of the routing table.
RIP-1 only sends the route with natural mask, that is, it always sends routes in the
route aggregation form. RIP-2 supports classless inter-domain routing (CIDR). To
advertise all the subnet routes, the route aggregation function of RIP-2 can be
disabled.
route aggregation form. RIP-2 supports classless inter-domain routing (CIDR). To
advertise all the subnet routes, the route aggregation function of RIP-2 can be
disabled.
Perform the following in the RIP View.
Cancel the filtering of the received
routing information imported by the
specified address
routing information imported by the
specified address
undo filter-policy gateway
ip-prefix-name import
ip-prefix-name import
Filter the received global routing
information
information
filter-policy { acl-number | ip-prefix
ip-prefix-name } import
ip-prefix-name } import
Cancel the filtering of the received
global routing information
global routing information
undo filter-policy { acl-number |
ip-prefix ip-prefix-name } import
ip-prefix ip-prefix-name } import
Table 549 Configuring RIP to filter the imported routes
Operation
Command
Filter the imported routing
information
information
filter-policy { acl-number | ip-prefix
ip-prefix-name } export [ routing-protocol ]
ip-prefix-name } export [ routing-protocol ]
Cancel the filtering of the
imported routing information
imported routing information
undo filter-policy { acl-number | ip-prefix
ip-prefix-name } export [ routing-protocol ]
ip-prefix-name } export [ routing-protocol ]
Table 548 Configuring RIP to filter the received routes
Table 550 Disabling host route
Operation
Command
Enable host route receiving
host-route
Disable host route receiving
undo host-route