3com 3031 Instruccion De Instalación

After the above configuration, execute the 

 commands in any view to 

display the operational information of multicast static routes, and to verify the 
effect of the configuration.

In the following networking environment, Routers RT1 and RT2 work in the OSPF 
domain. RT1 supports multicas but RT2 runs a unicast routing protocol. RT0 is a 
router that runs a multicast routing protocol outside the domain. For RT1 to get 
the multicast source information outside the domain through RT0 and the 
multicast source information in the domain through RT2, perform the following 
configuration.

Figure 158   Configuring a multicast static route 

Configure RT1:

<RT1> system-view

[RT1] ip rpf-route-static 0.0.0.0 0.0.0.0 ospf null0 preference 255

[RT1] ip rpf-route-static 0.0.0.0 0.0.0.0 tunnel1/0/0

Tthe first command allows the matching-rule-compliant multicast source 
information in the domain to pass the RPF check when it reaches RT1 through 
RT2. The second command alllows the multicast source information outside the 
domain to pass the RPF check when it reaches RT1 through tunnel1/0/0.

Table 762    Displaying and debugging multicast static routes

Display the configured multicast 
static routes

config [source mask ]

Display the active multicast static 
routes

[source mask ]

RT1

Tunnel1/0/0

RT0

OSPF Domain

RT2