3com 3031 Instruccion De Instalación
![3com](https://files.manualsbrain.com/attachments/960452ff43b9899cbcffced60c87abf956e7967a/common/fit/150/50/f6ac125d7af2cf40fec58935fa6d4bf71457a57efe50bee91208a434f325/brand_logo.jpeg)
790
C
HAPTER
57: AAA
AND
RADIUS C
ONFIGURATION
Perform the following configuration in System View.
If you give only the start IP address when configuring an address pool, it will
contain only one IP address.
contain only one IP address.
Assigning IP address for PPP user
The peer user IP address can be assigned on interface encapsulated PPP.
Perform the following configuration in interface view.
If the number of IP address pool is not specified, it defaults to 0, that is, the
remote-address pool
command equals to
remote-address pool 0
. You can use
the
ip pool
command in System View to configure an address pool.
By default, the system disables AAA server selection on the basis of DNIS number.
The DNIS number and server maps can take effect only after AAA server selection
on the basis of DNIS number has been enabled.
The DNIS number and server maps can take effect only after AAA server selection
on the basis of DNIS number has been enabled.
Configuring RADUIS
Server
You can configure RADIUS servers in either system or server template view. If you
want to create a RADIUS server template, you should first create a RADIUS server
template and enter its view.
want to create a RADIUS server template, you should first create a RADIUS server
template and enter its view.
Configuring a RADIUS server includes configuring its address, listening port, and
the RADIUS protocol related attributes like shared key, retry times, timeout
retransmission internal, designating authentication for PPP users, as well as the
time for a DOWN server to resume the UP state.
the RADIUS protocol related attributes like shared key, retry times, timeout
retransmission internal, designating authentication for PPP users, as well as the
time for a DOWN server to resume the UP state.
Configuring RADIUS Server Template
RADIUS server template is a group of RADIUS servers. A RADIUS server template
must be created before you can configure the servers of the RADIUS server
template.
must be created before you can configure the servers of the RADIUS server
template.
If the specified RADIUS server template does not exist, a new RADIUS server
template will be created and then enters the radius template view.
template will be created and then enters the radius template view.
In the radius template view, specific configuration of the RADIUS server template
can be performed.
can be performed.
Table 854 Configuring local IP address pool
Operation
Command
Configure local IP address pool
ip pool pool-number low-ip-address
[ high-ip-address ]
Remove local IP address pool
undo ip pool pool-number
Table 855 Assigning IP address for PPP user
Operation
Command
Assign IP address for PPP user
remote-address { ip-address | pool
[ pool-number ] }
Remove IP address assigned to PPP user
undo remote-address