3com 3031 Instruccion De Instalación

Perform the following in the User View.l

When using the 

 parameter to specify the tunnel names to be 

deleted, the system will delete all the tunnels with this name. When the 

 parameter is specified, only the specified tunnel will be deleted.

This configuration can enable/close a simple flow control function on the tunnel.

Perform the following in the L2TP Group Vview.

By default, the flow control function of Tunnel is disabled.

In LNS configuration task list, L2TP must be enabled and L2TP group must be 
created before configuring other functions. Regarding the configuration of L2TP 
supporting multi-instance, other configurations can only be valid after L2TP 
multi-instance function is enabled. For detailed introduction to related commands 
on PPP and Virtual-Template, refer to corresponding chapters and sections.

Corresponding configuration of LNS includes:

■

Enable L2TP (required)

■

Enable L2TP multi-instance function (optional)

■

Create L2TP group (required)

■

Create virtual template (required)

■

Set the parameters of call receiving (required)

■

Set local name (optional)

■

Set Tunnel authentication and password (optional)

■

Set the Transmission mode of the AVP data (optional)

■

Set sending time interval of hello packet in the tunnel (optional)

■

Force local CHAP authentication (optional)

■

Force LCP renegotiation (optional)

■

Set local address and assigned address pool (optional)

■

Set domain name delimiter and search sequence (optional)

■

Set user name and password and configure user authentication (optional)

■

Force to disconnect Tunnel (optional)

Table 953   Forcing to disconnect Tunnel

Force to disconnect Tunnel

reset l2tp tunnel { remote-name | 

tunnel-id }

Table 954   Setting flow control function of the tunnel

Enable flow control function of 
Tunnel

Disable flow control function of 
Tunnel