3com 5012 Manual De Usuario
3Com Router 5000/6000 Family
111
Command Reference
peer timer
Use the
peer timer
command to configure Keepalive and Holdtime intervals for a peer (group).
BGP view
peer upe
Use the
peer upe
command to configure BGP peer as the UPE of hierarchical BGP/MPLS VPN.
BGP view
permanent-active
Use the
permanent-active
command to configure BSV interfaces to permanent active.
BSV Interface view (in NTmode)
pfs
Use the
pfs
command to set the Perfect Forward Secrecy (PFS) feature for the IPSec policy to initiate the
negotiation.
IPSec Policy view
IPSec Policy Template view
phy-mru
Use the
phy-mru
command to configure in asynchronous flow mode MRU at the physical layer.
Asynchronous Serial Interface view
physical-mode
Use the
physical-mode
command to set the operating mode of the synchronous/asynchronous serial
interface.
Serial Interface view
pim
Use the
pim
command to enter PIM view.
System view
pim bsr-boundary
Use the
pim bsr-boundary
command to configure an interface to become the PIM domain boundary.
Interface view
pim dm
Use the
pim dm
command to enable PIM-DM.
Interface view
pim neighbor-limit
Use the
pim neighbor-limit
command to limit PIM neighbor number on an router interface. If the number
exceeds the limit configured, no new neighbor can be added to the router.
Interface view
pim neighbor-policy
Use the
pim neighbor-policy
command to configure a router to filter the PIM neighbor of the current
interface.
Interface view
pim sm
Use the
pim sm
command to enable PIM-SM protocol on an interface.
Interface view
pim timer hello
Use the
pim timer hello
command to configure the interval for sending PIM router Hello messages.
Interface view
ping
Use the
ping
command to test connectivity of an IP network and reachability of a host.
Any view
ping clns
Use the
ping clns
command to test the reachability to a specified destination.
Any view
ping ipx
Use the
ping ipx
command to check host reachability and network connectivity in IPX network.
Any view
pki delete-certificate
Use the
pki delete-certificate
command to delete the locally stored certificates.
System view