3com 5012 Manual De Usuario
3Com Router 5000/6000 Family
137
Command Reference
service vbr-nrt
Use the
service vbr-nrt
command to specify the service type of PVC as Variable Bit Rate-Non Real Time
(VBR-NRT) and specify the related rate parameters.
PVC view
service vbr-rt
Use the
service vbr-rt
command to set the service type of PVC to Variable Bit Rate- Real Time (VBR-RT)
and specify the related rate parameters in the PVC view.
PVC view
session algorithm-suite
Use the
session algorithm-suite
command to specify the algorithm suite a session uses.
Dvpn-Policy view
session idle-time
Use the
session idle-time
command to set the L2TP session idle-timeout timer. Upon expiration of this
timer, the L2TP session is disconnected.
L2TP Group view
session idle-timeout
Use the
session idle-timeout
command to set the idle timeout time for sessions.
Dvpn-Policy view
session keepalive-interval
Use the
session keepalive-interval
command to set the keepalive interval of sessions.
Dvpn-Policy view
session setup-interval
Use the
session setup-interval
command to set the interval for sending requests to establish a session
(Setup request). Setup request packets are sent regularly until the session is established.
Dvpn-Policy view
set authentication password
Use the
set authentication password
command to set a local authentication password.
User Interface view
set-overload
Use the
set-overload
command to configure overload flag bit for the current router.
IS-IS view
sftp
Use the
sftp
command to establish a connection to the remote SFTP server and enter SFTP client view.
System view
sftp server enable
Use the
sftp server enable
command to enable the secure FTP (SFTP) server.
System view
sftp source-interface
Use the
sftp source-interface
command to specify a source interface, which must be an existing local
interface, for the SFTP client. After that, the IP address of the specified interface is used as the source IP
address in each packet sent by the SFTP client.
address in each packet sent by the SFTP client.
System view
sftp source-ip
Use the
sftp source-ip
command to specify a source IP address for the packets sent by the SFTP client.
This IP address must be a local IP address.
System view
sham-link
Use the
sham-link
command to configure a sham link.
OSPF Area view
shdsl mode
Use the
shdsl mode
command to set the operating mode of the G.SHDSL interface.
ATM (G.SHDSL) Interface view
shdsl psd
Use the
shdsl psd
command to set PSD of the G.SHDSL interface working as CPE. It is not necessarily
the same as the one set at CO.
ATM (G.SHDSL) Interface view