3com 5012 Manual De Usuario
3Com Router 5000/6000 Family
141
Command Reference
sot sdlc-status primary
Use the
sot sdlc-status primary
command to set the role of the router to SDLC primary node.
Synchronous Serial Interface view
sot sdlc-status secondary
Use the
sot sdlc-status secondary
command to set the role of the router to SDLC secondary node.
Synchronous Serial Interface view
sot send address
Use the
sot send address
command to configure the route for sending SDLC frames to the specified
specific terminal.
Synchronous Serial Interface view
sot send all tcp
Use the
send all tcp
command to forward all received SDLC frames to the specified address.
Synchronous Serial Interface view
sot timer keepalive
Use the
sot timer keepalive
command to configure the keepalive timer.
System view
source
Use the
tunnel source
command to specify the source IP address or source interface to be filled in the
added IP header at the time of tunnel interface encapsulation.
Tunnel Interface view
source-interface
Use the
source-interface
command to configure the source interface in the transmitted test packets.
HWPing Test Group view
source-ip
Use the
source-ip
command to configure a source IP address for this test.
HWPing Test Group view
source-ip
Use the
source-ip
command to bind a source IP address to the router when it functions as a User Agent
(UA).
SIP Client view
source-policy
Use the
source-policy
command to configure a router to filter the multicast data packet received according
to source (group) address.
PIM view
source-port
Use the
source-port
command to configure a source port number for this test.
HWPing Test Group view
special-character
Use the
special-character
command to configure the supported special characters during register signal
exchange.
R2 CAS view
special-service
Use the
special-service
command to enable or disable the special-service numbers.
Voice Dial Program view
speed
Use the
speed
command to set the operating speed of the Ethernet interface.
Ethernet Interface view
speed
Use the
speed
command to configure the rate of the port.
Ethernet Port view
speed
Use the
speed
command to set the transmission rate on the user interface.
User Interface view
spf-delay-interval
Use the
spf-delay-interval
command to configure the interval for actively releasing CPU in the SPF
calculation.
IS-IS view