3com MSR 30-20 Instruccion De Instalación
Generic Modules
21
Generic Modules
The MSR 30 Series Routers support generic modules SIC and MIM. For details
about the interface cards, refer to H3C MSR 20/30/50 Series Routers Interface
Card and Interface Module Manual.
about the interface cards, refer to H3C MSR 20/30/50 Series Routers Interface
Card and Interface Module Manual.
SIC/DSIC Cards
MSR 30 series routers adopt modular design and support a wide range of optional
SIC/DSIC cards that provide various interfaces, such as synchronous/asynchronous
serial interface, Ethernet interface, E1/T1, ISDN BRI/PRI, ADSL, audio interface, and
Layer 2 switching interface.
SIC/DSIC cards that provide various interfaces, such as synchronous/asynchronous
serial interface, Ethernet interface, E1/T1, ISDN BRI/PRI, ADSL, audio interface, and
Layer 2 switching interface.
SIC cards mainly differ from DSIC cards in that a SIC card occupies one ordinary
SIC slot while a DSIC card occupies two (horizontal) SIC slots. You need to remove
the slide rails from the router before installing a DSIC card.
SIC slot while a DSIC card occupies two (horizontal) SIC slots. You need to remove
the slide rails from the router before installing a DSIC card.
n
A PoE-capable interface card can supply power remotely only when it is installed in
a PoE router. If it is installed in a non-PoE router, it serves as an ordinary switching
module only.
a PoE router. If it is installed in a non-PoE router, it serves as an ordinary switching
module only.
For the MSR 30-11, SIC/DSIC cards are subject to the following limitations:
■
SIC-4FSW/1FEA/1GEC/1ADSL/1ADSL-I can be installed only in slot 2.
■
SIC-2BS/2BU/2BSV is not supported.
■
SIC-1BS/1BU/1BSV/1EPRI/1E1-F/1TPRI/1T1-F can be installed only in slot 1.
For the MSR 30-16, SIC/DSIC cards are subject to the following limitations:
■
SIC-4FSW/1FEA/1GEC/1ADSL/1ADSL-I can be installed only in slot 2 or slot 4.
■
SIC-2BS/2BU/2BSV can be installed only in slot 1 or slot 3.
For the MSR 30-20/40/60, SIC/DSIC cards are subject to the following limitations:
■
SIC-4FSW/1FEA/1GEC/1ADSL/1ADSL-I can be installed only in slot 2 or slot 4.
ESM0 to 1
OFF means no ESM is in the ESM slot.
Steady green means an ESM is in the ESM slot and operates
normally.
normally.
Blinking green means the ESM is processing data.
Solid yellow means an ESM is in the ESM slot but does not operate
normally.
normally.
VCPM
OFF means no VCPM is in the slot.
Steady green means a VCPM is in the slot and operates normally.
Steady yellow means a VCPM is in the slot but does not operate
normally.
normally.
VPM0 to 2
OFF means no VPM is in the VPMx slot.
Steady green means a VPM is in the VPMx slot and operates
normally.
normally.
Steady yellow means a VPM is in the VPMx slot but does not operate
normally.
normally.
Table 14 Rear panel LEDs of H3C MSR 30-60 Router
LED Description