3com MSR 30-20 Instruccion De Instalación
88
C
HAPTER
6: H
ARDWARE
M
AINTENANCE
Installing CF Card
Install the CF card following these steps:
Step 1: Push the ejector button into the slot completely, and make sure it only
springs out with outside force.
springs out with outside force.
Step 2: Press the CF card into the slot in correct orientation, and make sure it only
pops up with outside force.
pops up with outside force.
Figure 77 Press the CF card into the slot
n
Make sure the CF card with correct application program is properly installed in the
slot; or, the system cannot boot.
slot; or, the system cannot boot.
Removing CF Card
Remove the CF card following these steps:
Step 1: Check the CF card LED to make sure it is not blinking, and then proceed.
Step 2: Press the spring button to release the internal spring clip, making the card
out of the slot a little.
out of the slot a little.
Step 3: Push the spring button hard in the orientation shown in the figure below,
and the CF card on the right pops up a little. Take it out.
and the CF card on the right pops up a little. Take it out.
Figure 78 Press the spring button to make the card spring out
c
CAUTION: Do not insert or remove the card when the router is booting or the LED
is blinking to avoid hardware damage.
is blinking to avoid hardware damage.
Replacing a Memory
Module
Module
n
The memory module on the MSR 30-11 is irreplaceable.
This section describes how to replace a memory module. See Figure 79.