Pico Macom dsp806 Guía Del Usuario

Rev. 01/03

warranty.

This product should be operated only from the

type of power source indicated on the marking label. If you are not
sure of the type of power supplied to your home, consult your appli-
ance dealer or local power company.

Power supply cords should be routed

so they are not likely to be walked on or pinched by items placed upon
or against them. Pay particular attention to cords and plugs, conven-
ience receptacles, and the point where they exit from the appliance.

For added protection for this product during a light-

ning storm, or when it is left unattended or unused for long periods of
time, the unit should be disconnected from power source.

An outside antenna system should not be locat-

ed in the vicinity of overhead power lines, other electric light or power
circuits, where it can fall into such power lines or circuits. When
installing an outside antenna system, extreme care should be taken
to keep from touching such power lines or circuits as contact with
them may be fatal.

Do not overload wall outlets and extension cords

as this can result in risk of fire or electric shock.

Never push objects of any kind into

this product through openings as they may touch dangerous voltage
points or short-out parts that could result in a fire or electric shock.
Never spill liquid of any kind on the product.

Do not attempt to service this product yourself as

opening or removing covers may expose you to dangerous voltage or
other hazards. Refer all servicing to qualified service personnel.

Unplug this product from the wall

outlet and refer servicing to qualified service personnel under the fol-
lowing conditions:

a. When the power-supply cord or plug is damaged.

b. If liquid has been spilled, or objects have fallen into the product.

c. If the product has been exposed to rain or water.

d. If the product does not operate normally by following the operating

instruction. Adjust only those controls that are covered by the oper-
ating instructions. An improper adjustment may result in damage
and will often require extensive work by a qualified technician to
restore the product to its normal operation.

e. If the product has been dropped or the cabinet has been damaged.

f. When the product exhibits a distinct change in performance - this

indicates a need for service.

When replacement parts are required, be

sure the service technician has used replacement parts specified by
the manufacturer or have the same characteristics as the original
parts. Unauthorized substitutes may result in fire, electric shock or
other hazards.

Upon completion of any service or repairs to this

product, ask the service technician to perform safety checks to deter-
mine that the product is in proper operating conditions.

Before attempting to install this

product, be sure the antenna or cable system is grounded so as to

provide some protection against voltage surges and built-up static
charges.

a. Use No.10 AWG (5.3mm) copper, No.8 AWG (8.4mm) aluminum,

No.7 AWG (10mm) copper-clad steel or bronze wire or larger, as

ground wire.

b. Secure antenna lead-in and ground wires to house with stand off

insulators spaced from 4 feet (1.22m) to 6 feet (1.83m) apart.

c. Mount antenna discharge unit as close as possible to where lead-

in enters house.

d. A driven rod may be used as the grounding electrode where other

types of electrode systems do not exist. Refer to the National

Electrical Code, ANSI/NFPA 70-1984 for information.

e. Use jumper wire not smaller than No.6 AWG (13.3mm) copper or

equivalent, when a separate antenna grounding electrode is used.

THIS REMINDER IS PROVIDED TO CALL THE CATV SYSTEM
INSTALLER’S ATTENTION TO ARTICLE 820 - 40 OF THE NEC
THAT PROVIDES GUIDELINES FOR PROPER GROUNDING
AND, IN PARTICULAR, SPECIFIES THAT THE  CABLE
GROUND SHALL BE CONNECTED TO THE GROUNDING
SYSTEM OF THE BUILDING, AS CLOSE TO THE POINT OF
CABLE ENTRY AS PRACTICAL.