Gestetner c7528 Guía De Operación
Making Printer Settings Using the Control Panel
166
❒ If the [HD Format] button is not displayed, the hard disk unit is not properly
installed. Reinstall the hard disk unit. For details about the hard disk unit,
see Setup Guide. If you cannot install it properly even after attempting re-
installation, contact your sales or service representative.
see Setup Guide. If you cannot install it properly even after attempting re-
installation, contact your sales or service representative.
Displaying the signal strength
Follow the procedure below to check the IEEE 802.11b (wireless LAN) signal on
the [Maintenance] menu.
the [Maintenance] menu.
A
Press the {Menu} key.
The [Menu] screen appears.
B
Press the {T} or {U} key to display [Maintenance], and then press the {#
Enter} key.
Enter} key.
C
Press the {T} or {U} key to display [WL.LAN Signal], and then press the {#
Enter} key.
Enter} key.
Check the display for result.
D
Press the {Escape} key.
The initial screen appears.
❒ If [WL.LAN Signal] is not displayed, [IIEEE 802.11b] has not been selected for
[LAN Type] in [Network Setup] on the [Host Interface] menu. Select [IEEE
802.11b] for [LAN Type], and then check that [WL.LAN Signal] is displayed on
the [Maintenance] menu again.
802.11b] for [LAN Type], and then check that [WL.LAN Signal] is displayed on
the [Maintenance] menu again.
❒ Signal status can be measured in [Infrastructure] under [Comm. Mode] of the
wireless LAN. If [Ad hoc] or [802.11 Ad hoc] is selected in [Comm. Mode], sig-
nal status cannot be measured. To measure signal status, select [Comm.
Mode] in [Infrastructure] under [IEEE 802.11b] on the [Host Interface] menu.
nal status cannot be measured. To measure signal status, select [Comm.
Mode] in [Infrastructure] under [IEEE 802.11b] on the [Host Interface] menu.
❒ Every time you press the {# Enter} key, the signal is updated.