Gestetner 2045 Manual De Usuario
Transmission Mode
10
1
❒ You can set whether a Polling
Transmission file is deleted after
transmitting in “User Parameters”.
To save the file to transmit repeat-
edly, set to “Standby (Save)”. See
p.147 “Changing the User Parame-
ters” (switch 11, bit 7).
transmitting in “User Parameters”.
To save the file to transmit repeat-
edly, set to “Standby (Save)”. See
p.147 “Changing the User Parame-
ters” (switch 11, bit 7).
❒ You can program one of the Quick
Operation keys with operations for
this function. Using the key allows
you to omit steps
this function. Using the key allows
you to omit steps
B and C.
❒ The communication fee is charged
to the receiver.
AAAA
Place the original, and then select
the scan settings you require.
the scan settings you require.
BBBB
Press [Transmission Mode].
CCCC
Select [Polling TX].
DDDD
Depending on the Polling Trans-
mission mode, use one of the fol-
lowing procedures:
mission mode, use one of the fol-
lowing procedures:
Free Polling Transmission
A Check that [Free Polling TX] is se-
lected.
Default ID Transmission
A Select [Default ID TX].
ID Override Transmission
A Select [ID Override Transmission].
B Specify a 4-digit ID using the
B Specify a 4-digit ID using the
number keys and [A], [B], [C],
[D], [E], and [F].
[D], [E], and [F].
Note
❒ A Polling ID may be any four
numbers (0 to 9) and charac-
ters (A to F), except 0000 and
FFFF.
ters (A to F), except 0000 and
FFFF.
❒ If you make a mistake, press
[Clear]
or the
{{{{Clear/Stop}}}} key,
and then try again.
EEEE
Press [Only Once] or [Save] to delete
or save the file after transmission.
or save the file after transmission.
Note
❒ To delete the original immedi-
ately after transmission, select
[Only Once]
[Only Once]
.
❒ To repeatedly send the original,
select [Save].
❒ To cancel Polling Transmission,
.