Gestetner 5308l Guía Del Usuario

105

• While printing, do not turn off the main switch.
• While printing, do not open the door or covers.
• While printing, do not unplug the power cord.
• While printing, do not move the machine.
• Keep corrosive liquids, such as acid, off the machine.
• Open and close the door and covers softly.
• Do not put anything except originals on the machine.
• Do not spill liquid on the machine.
• When opening or closing the door or covers, keep hold of them so they don't

fall.

• When removing the drum unit from the machine, be careful not to let the

drum unit fall.

• Do not modify or replace any parts other than the ones specified in this man-

ual.

• Do not operate the machine without covers. You might get your fingers

caught in the machine, or the machine might be damaged because, for exam-
ple, dust or the like might get inside.

• Since some parts of the machine are sharp and might cause injury, touch only

the parts specified in this manual.

• If you clean rubber parts with benzine, wipe them with a dry cloth after-

wards.

• Always turn the machine off when you have finished printing for the day.
• If the machine must be transported by vehicle, please contact your service

representative.

• Make sure to make a few trial prints to check the image position because the

image position of the trial print might not correspond with that of the origi-
nal.

• If the image registration is not consistent, slow the printing speed down to

Setting 0.

• When performing duplex or multicolored printing, leave the printed paper

for a while before the next printing in order to let the ink dry on the printed
paper. If this is not done, feed roller marks will appear on the print image.