Gestetner 5450 Manual De Referencia
52
Installing SIMMs.
Note
For configurations where two SIMMs are to be
installed, always begin installation with slot 2.
installed, always begin installation with slot 2.
Refer to the SIMM-slot placement rules at the
beginning of this Appendix for information as to
which type of SIMM is installed into which slot.
beginning of this Appendix for information as to
which type of SIMM is installed into which slot.
1. Remove the new SIMM from its antistatic
package. Hold the board with your forefingers on
the side edges and your thumbs against the back
edge, as shown in Figure B-1.8. Turn the board
so the notch on one end is on the bottom and the
metal teeth face toward the slot.
the side edges and your thumbs against the back
edge, as shown in Figure B-1.8. Turn the board
so the notch on one end is on the bottom and the
metal teeth face toward the slot.
Figure B-1.8. Positioning the SIMM.
2. Hold the SIMM board at a 30-degree angle to the
slot and push the edge of the board evenly and
firmly into the slot, as shown in Figure B-1.9.
firmly into the slot, as shown in Figure B-1.9.