Gestetner 9980 Manual De Usuario

How to Set a Document

35

In this manual a document can mean
a single or multiple page document.
You can set your documents either in
the Auto Document Feeder (ADF) or
document bypass tray.

The direction in which you should set
the document in the Auto Document
Feeder (ADF) depends on the docu-
ment size:

❖

❖

❒ When sending a fax, the image

output at the other end depends on
the size and direction of paper
used in the receiver's terminal. If
the receiver does not use paper of
the same size and direction as that
of the document, the fax image
may be output reduced, trimmed
at the both edges, or divided into
two or more sheets. When sending
an important document, we rec-
ommend you to ask the receiver
about the size and direction of the
paper used in their terminal.

❒ It is possible to set A4 L and A4 K

documents as you would A5 or B5
documents, but there is no guaran-
tee that they will be sent correctly.

❒ Make sure that all ink, correcting

fluid etc., has completely dried be-
fore setting your document. If it is
still wet, the scanner glass will be
marked and those marks will ap-
pear on the received image.

Use the Auto Document Feeder
(ADF) to scan in a stack of documents
in one operation. 

❒ You can scan in documents of up

to 23.7" in length.

❒ Place all the documents to be sent

in a single stack. 

❒ You cannot set documents in the

Auto Document Feeder (ADF) one
page at a time or in sheaves.

Original

Where Original is set

GFGSET0N

Direction in which to set document

Original

GFGSET1N