Gestetner dsc332 Guía De Operación
Replacing the Fuser Oil Unit
145
6
Replacing the Fuser Oil Unit
R WARNING:
R CAUTION:
If the message “
Fuser Oil Unit Re-
placement.
”, “
Fusing oil is emp-
ty.
”, and “
Please replace Fuser
Oil Unit.
" are displayed, either re-
place it on your own by following the
procedure below or call your service
representative.
procedure below or call your service
representative.
Note
❒ Service differ depending on the
maintenance service contract.
AAAA
Turn off the power, and then un-
plug the power cable.
plug the power cable.
Important
❒ Be sure to wait about an hour to
avoid burns.
BBBB
If the finisher is installed, detach
it from the machine.
it from the machine.
CCCC
Open the duplex reversal unit.
DDDD
Slowly pull out the left cover.
EEEE
Open the upper left cover.
• Do not incinerate spilled toner
or used toner. Toner dust
might ignite when exposed to
an open flame.
might ignite when exposed to
an open flame.
• The inside of the machine be-
comes very hot. Do not touch the
parts with a label indicating a “hot
surface”. Otherwise, an injury
might occur.
parts with a label indicating a “hot
surface”. Otherwise, an injury
might occur.
• Keep toner (used or unused) and
the toner cartridge out of reach of
children.
children.
• The fusing unit becomes very
hot. When installing a new fuser
oil unit, turn off the machine and
wait about an hour. After that, in-
stall the new fuser oil unit. Not
waiting for the unit to cool could
result in a burn.
oil unit, turn off the machine and
wait about an hour. After that, in-
stall the new fuser oil unit. Not
waiting for the unit to cool could
result in a burn.
• Keep the fuser oil unit away from
flames. There is a risk of fire or
burns.
burns.
AAE022S
AAE023S
AAE024S
0816JupiterC1GSG_GB_FM.book Page 145 Friday, August 29, 2003 7:56 PM