Gestetner dsm616 Guía De La Red
Remote Maintenance by telnet
91
9
Note
❒ When changing the interface to
IEEE 802.11b, see p.82 “TCP/IP
address”.
address”.
❒ When configuring the IEEE 802.11b
TCP/IP, see p.82 “TCP/IP ad-
dress”.
dress”.
Changing the host name
Use the “hostname” command to
change the printer name.
change the printer name.
msh> hostname interface_name
printer_name
printer_name
*1
If you did not enter the interface
name, it will be automatically set to
the Ethernet interface.
*2
Available when the optional 802.11b
interface unit is installed.
*3
Available when the optional 1394 in-
terface board is installed.
enc [on|off]
You can enable or
disable the WEP
function. To enable
the WEP function,
select [on]; to disa-
ble it, select [off].
To start the WEP
function, enter the
correct WEP key.
disable the WEP
function. To enable
the WEP function,
select [on]; to disa-
ble it, select [off].
To start the WEP
function, enter the
correct WEP key.
key [key value]
64-bit or 128-bit
can be set.
can be set.
Only 10 hexadeci-
mal characters can
be set when using
64-bit; or 26 hexa-
decimal characters
when using 128-
bit.
mal characters can
be set when using
64-bit; or 26 hexa-
decimal characters
when using 128-
bit.
Also, set 0x as the
prefix.
prefix.
To use this func-
tion, set the same
WEP key for all
ports that transmit
to each other.
tion, set the same
WEP key for all
ports that transmit
to each other.
auth
[open|shared]
[open|shared]
You can set the au-
thorized mode
when using WEP.
The specified val-
ue and the author-
ized mode are as
follows:
thorized mode
when using WEP.
The specified val-
ue and the author-
ized mode are as
follows:
open: Open system
authorized (de-
fault)
authorized (de-
fault)
shared: Shared key
authorized
authorized
Parameter
Value to be con-
figured
figured
rate [au-
to|11m|5.5m|2m
|1m]
to|11m|5.5m|2m
|1m]
You can set the
IEEE 802.11b trans-
mission speed.
IEEE 802.11b trans-
mission speed.
The transmission
speed you specify
here is the speed at
which data is sent.
You can receive
data at any speed.
speed you specify
here is the speed at
which data is sent.
You can receive
data at any speed.
auto: automatical-
ly set (default)
ly set (default)
11m: 11 Mbps
fixed
fixed
5.5m: 5.5 Mbps
fixed
fixed
2m: 2 Mbps fixed
1m: 1 Mbps fixed
Interface name
Interface to be config-
ured
ured
ether
Ethernet interface
IEEE 802.11b interface
IEEE 1394 interface
Parameter
Value to be con-
figured
figured