Gestetner dsm725e Guía De La Red
Monitoring and Configuring the Printer
58
2
Remote Maintenance by telnet
Important
❒ Remote Maintenance should be password-protected so that access is allowed
to administrators only.
❒ The password is the same as the one of Web Image Monitor administrator.
When the password is changed using “mshell”, other passwords change also.
❒ Some command cannot be set depending on the model type.
Using telnet
Follow the procedure below to use telnet.
Important
❒ Only one user at a time can log on to perform remote maintenance.
A
Use the IP address or the host name of the machine to start telnet.
% telnet IP_address
B
Enter your user name and password.
For details about the user name and password, consult your network admin-
istrator.
For user authentication, enter a login user name and password.
For user code authentication, enter a user code in User Name.
For details about the user name and password, consult your network admin-
istrator.
For user authentication, enter a login user name and password.
For user code authentication, enter a user code in User Name.
C
Enter a command.
D
Quit telnet.
msh> logout
The configuration message about saving the changes appears.
E
Enter “yes” to save the changes, and then press the {Enter} key.
If you do not want to save the changes, enter “no”, and then press the {Enter}
key. To make further changes, enter “return” at the command line, and then
press the {Enter} key.
If you do not want to save the changes, enter “no”, and then press the {Enter}
key. To make further changes, enter “return” at the command line, and then
press the {Enter} key.
Note
❒ If the message “Can not write NVRAM information” appears, the changes
are not saved. Repeat the procedure above.
❒ When the changes are saved, the network interface board is reset automat-
ically with that changes.
❒ When the network interface board resets, the print job in print process will
be printed. However, print jobs in queue will be canceled.